Jinbao Biogas Fast Decomposition is the latest generation of biogas that has been developed through a series of high-tech techniques such as separation, purification, and rejuvenation using a combination of international high-end microbiological engineering technology, such as the United States, Japan and South Korea, combined with its own intellectual property and patented technologies. Fast rot agent, which belongs to the domestic first natural compound fermentation bacterium, its original strain is taken from the soil layer in the deep mountain jungle, this product is a good (consumption) oxygen type fermentation agent, the fermentation speed is fast, the operation is simple, without accessories The fermentation of various crop straws and forages can be transformed to make the lignin, cellulose, hemicellulose, pectin and wax compounds in the straw destroyed, and the contact surface with the bacteria is increased, thus better Decomposed and used by bacteria has greatly improved the prevention of crusting, rapid start-up, increase of gas production, and improvement of gas production efficiency.
two. Product Features
1. Saving rot time, early entry into the gas production stage, straw is difficult to digest, and lignin, fiber, etc. are difficult to be decomposed. For example, use Gumbo biogas fast rot to enter the digester after treatment, which will obviously save the decay time and enter the gas production stage in advance. Save 60% of your time.
2. Preventing crusts and affecting the surface of gas-producing straw has a layer of wax that is not easily destroyed by biogas microorganisms. If the straw directly under the pool will be a large number of floating crust, and has not been fully utilized decomposition, affecting gas production and gas production efficiency, such as before entering the pool with Glyphon biogas fast rot agent after processing it destroyed, can increase gas production 30 -50%.
3. Increased gas production and gas production efficiency After the raw materials are processed, the fermentation time in the pool is naturally reduced, and the gas production starts when the inlet temperature reaches the required level. If the raw material is used in combination with Gumbo biogas starter, the startup time can be reduced by half. , can increase 50-100% of gas production.
three. Instructions:
(1) Chopped or coarsely crushed 10 straws (about 1-2 tons in dry weight) are used to cut the straw to a length of about 60 millimeters with a guillotine blade, so as to save the cost, it is not necessary to roughly smash. This can not only damage the surface of the straw Wax layer, and increase the contact surface of fermentation raw materials and bacteria, can accelerate the decomposition of raw materials. At the same time, it is also convenient for operation during discharge and fertilization. After the chopped and coarse-grained straw is fermented under the pool, the gas production can generally be increased by about 20%. Stacking into large piles must be done while pressure is on the sides of the stack, and the volume should be reduced as much as possible.
(2) Preparation of fermentation broth: The urea water is then made from 2.5 kg Urea to 150-200 kg of water and spread evenly on the straw heap. The water content of the fermented heap is required to reach 60-70%. (Water judging method: grasping a handful of materials, see the water is not dripping, landing is scattered is appropriate). Wait until the urea water is saturated, cover with a breathable cover, naturally placed for 24 hours, the next day to 1 kg Jinbao biogas Mix the fast rot with 5 kg of rice bran and dilute it evenly in the piled straw. After inoculation, cover it again and protect from light and rain.
(3) Stacking processing The stacking time is 2 to 3 days in summer and 5 to 7 days in winter. When the stack is hot and hot (50-60°C), immediately turn the stack and pour it out of the stack into the heap and add some water. When the color of most straws turns from yellow to soft and then black or brown, A pull is broken, you can put into the digester fermentation.
Sunson Leather Enzyme is developed for leather industry. Soaking enzyme mainly used in soaking, can also be used in combination with other chemical agents. It can be widely used for soaking process in all kinds of dry hide, wet salted hide, fresh hide. Liming enzyme mainly used in liming, can also be used in combination with other chemical agents. Acid bating enzyme suited for all tanning operations in the acid side, such as, Pickling, Acid bating, Wet-Blue reconditioning and so on. Alkaline bating enzyme suited for all skin softening. Remove the non-fibrous proteins and dissoluble proteins.
Sunson group provides Lipase, Protease, Alkaline Lipase, Acid Lipase For Leather industry.
Benefits:
The effectiveness is tender, balanced. Effectively improve the pliability and fullness of the leathers, increase the yield of leather output. When used in Wet-Blue reconditioning, it promotes the absorption of tanning agent and improve the dyeing uniformity, it has very good permeability, evenly soften effect can be obtained. Its use will not lead to loose grain on leather.
This product should be stored in a cool and dry place in sealed container, avoiding insolation, high temperature and damp. The product has been formulated for optimal stability. Extended storage or adverse conditions such as higher temperature or higher humidity may lead to a higher dosage requirement.
Enzyme preparations are proteins, which may induce sensitization and cause allergic type reactions in sensitized individuals. Prolonged contact may cause minor irritation for skin, eyes or nasal mucosa, so any direct contiguity with human body should be avoided. If irritation or allergic response for skin or eyes develops, consult a doctor.
Leather Enzymes,Enzymes For Leather,Enzymes Used For Leather,Enzymes For Leather Industry,Lipase For Leather
Sunson Industry Group Co., Ltd , https://www.sunsonchinaenzymes.com