The concentration of carbon dioxide incubator is set in two presets: direct setting and direct setting. Press the group to adjust the set concentration while viewing. The setting work can be done at one time; the latter can be directly based on the scale on the setting. Set (HH.CP-T type), but due to the large scale error, it must be adjusted after the concentration is stable.
Daily maintenance of carbon dioxide incubator Carbon dioxide incubator is expensive and has a long continuous running time. It should be taken care of in use. In order to keep the culture environment free of pollution, the box should be cleaned and disinfected regularly. After the calibration and various parameter setting work is completed, it is necessary to prevent random movement, especially for instruments without locking devices. Turn off carbon dioxide in a timely manner when carbon dioxide culture conditions are not required: control the system's power supply. For equipment without this independent power supply, the carbon dioxide: setting button should be turned back to zero to close the solenoid valve. When the cylinder pressure is low and dry at 0.skg/cm, it should be ventilated in time to prevent the solenoid valve from being burnt due to long-term energization in the case of gas shortage and no one. High quality carbon dioxide: gas should be used as the gas source. Distilled water should be added to the insulated water tank and an appropriate amount of preservative should be added.
Moisturizing Series:Hyaluronic Acid, Collagen,Allantoin, Polyglutamic Acid, D-Panthenol, Mango Butter,Ceramide Shea Butter, Cocoa Butter, Sodium Pyrrolidone Carboxylate,Jojoba Oil ,
Moisturizing means moisturizing the skin. When the air temperature decrease, the skin cutin layer can't timely adjust enough moisturizing factor, sebum gland activity decreased, grease, moisture falling on her face, the skin will be tight phenomenon, even in the current and near nose fine lines, through the use of a corresponding effect of skin, keep skin is tasted, nourish the skin and prevent skin evaporation, improve microcirculation, enhance the process of skin moisture, It's called moisturizing, and the best moisturizing is the positive interaction between skin and moisturizing products.
Air humidity is reduced, the cuticle of the skin cannot adjust enough protect wet factor in time, and the active ability of grease gland is also in decrease, the grease on the face will be reduced, because this skin is easy to take up, be in at present reach nasal side more can appear fine line. Moisturize well to prevent fine lines, to do a good job of moisturizing, is to let the skin maintain more water, so as to reduce the dry caused by fine lines.
Hyaluronic Acid,Collagen,Allantoin,Polyglutamic Acid,D-Panthenol,Mango Butter
Xi'an Henrikang Biotech Co.,Ltd , https://www.henruikangbio.com