Magnetic Flip Level Gauge Application Notes

The magnetic flip column level gauge series can achieve high sealing, anti-leakage and safe and reliable measurement of liquid level under high temperature, high pressure, high viscosity and strong corrosive conditions. The whole process measurement has no blind zone, the display is eye-catching, the reading is intuitive, and Large measuring range, equipped with liquid level alarm and control switch, can realize upper and lower limit alarm and control of liquid level or boundary position, coupled with HJ-YBS type liquid level transmitter, can convert liquid level and boundary signal into Two-wire 4 to 20mADC standard signals for remote detection, indication, recording and control. HJ-CUZ magnetic flip column liquid level meter series products are widely used in liquid level measurement and control in the production process of electric power, petroleum, chemical, metallurgy, environmental protection, shipbuilding, construction, food and other industries.

Magnetic flip column level gauge application notes:

1. The side-mounted liquid level and the upper and lower liquid-discharging tubes of the container to be tested are each equipped with a shut-off valve to open or total the liquid level gauge, and on the other hand, it is convenient for the maintenance of the liquid level. When the upper and lower stop valves are closed, open the drain flange at the bottom of the level gauge or remove the drain screw. Fill the water to clean the body of the level gauge.

2. Install the liquid level gauge. The vertical line of the flange center line is ‰4‰. When the measuring range of the liquid level gauge is more than 3 meters, it is necessary to consider adding the intermediate reinforcing flange (or ear climbing) as a fixed support to increase the strength.

3. The cross-sectional area of ​​the core wire connecting the transmitter of the remote transmission level gauge and the secondary instrument should be greater than 0.8mm2. When laying parallel with the AC power supply, keep at least 20cm away. Laying the iron pipe or laying it with a two-core cable, the layer can only be grounded at one end.

4, the selection of the liquid level controller, its contact capacity, are designed with resistive load. If non-resistive or high-power load is used, the intermediate relay should be used for conversion.

5. For liquid crystals containing suspended impurities and philophilic substances, it is not advisable to use this level gauge (because these impurities can cause jamming on the float assembly)